![]() Next, use a plastic trim tool to remove the five plastic rivets securing the bottom of the bumper cover to the frame of the vehicle.Start by using a phillips screwdriver to remove the engine splash shields (if they are present.on a lot of cars one, or both, may have “disappeared” over the years). Move underneath the front end of the vehicle.They should come out with a phillips screwdriver.if not they may need a little “help” with a plastic trim removal tool. Even though only the bottom one is holding the bumper cover, the other two must be removed in order to slide the front end of the car into its service position (see section 4 below). Next, remove all three plastic phillips head rivets located in the wheel well in front of the tire.Starting on the left side of the vehicle, use a T25 torx bit to remove the bolt anchoring the side of the bumper to the frame.Jack and support the front of your vehicle using the jack stand method as shown in our article BMW Jacking and Supporting for Repairs and Maintenance.Section 2 - Removing the Front Bumper Cover The front bumper cover must be removed to access more bolts anchoring the front end of the vehicle to the frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |